Winding Multiple Choice Questions (MCQ) PDF - 300

MCQ 1496: If the set parameter for cleaning are exceeded then yarn is

1. cut
2. spliced
3. torn
4. both a and b

MCQ 1497: In order to check fibers without causing any eventual problems, the different points of the teeth of the controller must operate at speed

1. within the feed and draft values
2. feed value
3. draft value
4. greater than draft value

MCQ 1498: The oiling device at the exit side features

1. spikes
2. tube
3. nozzle
4. spraying compartment

MCQ 1499: The entry and exit sides of slivers into or from drawframe may integrate

1. oiling devices
2. control devices
3. computerized devices
4. rotating devices

MCQ 1500: Rough untangling of tufts is done by

1. bale plucker
2. blending chamber
3. weighing feeder
4. feeder table